Published
2023-06-03
Section
Articles
License
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
How to Cite
SCIENTIFIC ANALYSIS OF THE PROCEDURE FOR PREPARING THREADS FOR THE WEAVING PROCESS
Toshtemirov Qosimjon Abdullaxayevich
Assistant, Fergana Polytechnic Institute, Department of Natural Fibers, Fergana, Uzbekistan
Keywords: textile yarn, grain, hairiness, cookedness, roughness, breaking strength, product, quality, carding, re-carding, carding.
Abstract
In the article, the method of preparation of yarns for the weaving process, and the physical and mechanical properties of the yarns are analysed by comparing them with the properties of ordinary weaving yarns of the enterprise. According to the results of the research, the yarns in the weaving of gauze knitwear and textile products are formed by the interweaving of individual threads in a certain composition. One of the threads passes over or under the other, at a right angle It was found out in the results of the research that it is of high quality and strong when it is woven in a straight line.References
Қулметов М., Очилов Т., Абдулина Ф. (2009). Маҳсулот сифатини баҳолаш ва бошқариш. Дарслик, Тошкент, 3 б.
Марасулов Ш.Р. (1985). Пахта ва кимёвий толаларни йигириш. Тошкент, Ўқитувчи. 304 б.
К.Ж.Жуманиязов, Х.Т.Бобожанов, Ж.К.Гафуров. (2009). Сравнение устройств для компактной кольцевой пряжи, Тўқимачилик муаммолари, №4, 19-21 б. ROTORCRAFT compact spinning (www. oe-rotorcraft. com).
Очилов Т., Кулметов М. ва бошқалар. (2005). Тўқимачилик материалшунослиги. Тошкент, 67 б.
Salimov, A., & Salimov, O. Sh. Khusanova, I. Khakimov “The problems of natural fiber and textile materials on fire resistance” Saarj journal Akademicia: an international multidisciplinary research journal april-2020.
Sarimsakov, O. S. N., & Sh, S. Z. X. (2020). Improvement of the Process in Disassembling of Cotton Stack and Transfering the Cotton into Pneumotransport. International Journal of Advanced Science and Technology, 29(7), 10849-10857.
Shohida, K., & Khurshidbek, I. (2022). Investigation of ways to increase the speed of the raw material roller on the ginning equipment. Universum: технические науки, (2-7 (95)), 40-42.
Zikirov, M. C., Qosimova, S. F., & Qosimov, L. M. (2021). Direction of modern design activities. Asian Journal of Multidimensional Research (AJMR), 10(2), 11-18.
